PCle 3.0 Extender and Jumper
10Gtek’ s PCle Extender and Jumper series own ultra-excellent quality to meet the Gen 3.0 or Gen 4.0 system. Using 3M's twin-ax cable, the PCle Extender and Jumper can be very flexible. The cable is thin and flat, which leads the extensive cable solution being high-density and tending to save the space, maximizing the space utilization. Both the Jumper (Male to Male) and the Extender (Male to Female) pro- vide PCle x8 and x16. Available in 10 cm to 150 cm length, 10Gtek PCle 3.0 Extender and Jumper series support a wide range of GPU solutions and match the cable included in any chassis. Besides, we also provide the optional choice that integrated an electrical power supply cable.
Besides parameters mentioned above are available for customized design, including cable length, connector PCB design, power pin design, we also provide custom design for impedance (85-ohm or 100-ohm).
No matter the receptacle connector(female) or card edge connector(male), both of two sides are designed to meet the requirements of PCle architectures that call for a high-performance point-to-point full duplex I/O Bus connectors.
- PCle 2.0, PCle 3.0
- Potential cost savings via FR4 and re-driver elimination
- x8. x16 lane
- 25-cm,50-cm are standard length
- Customized available
- Data Center
|PCIe x8 Extender, Male to Female, 25cm
|PCIe x8 Extender, Male to Female, 50cm
|PCIe x8 Extender, Male to Female, 75cm
|PCIe x8 Jumper, Male to Male, 25cm
|PCIe x8 Jumper, Male to Male, 50cm
|PCIe x8 Jumper, Male to Male, 75cm
|PCIe x16 Extender, Male to Female, 25cm
|PCIe x16 Extender, Male to Female, 50cm
|PCIe x16 Extender, Male to Female, 75cm
|PCIe x16 Jumper, Male to MaIe, 25cm
|PCIe x16 Jumper, Male to Male, 50cm
|PCIe x16 Jumper, Male to Male, 75cm